How to Reset a Sump Pump: A Step-by-Step Guide
If your sump pump isn’t working, you may be wondering how to reset it. A sump pump is an important part of your home’s drainage system, and if it isn’t working properly, you could end up with a lot of water damage.
In this guide, we will provide a step-by-step guide on how to reset a sump pump.
When is the Time to Reset the Sump Pump?
If you notice that your basement is starting to flood, or that there is a lot of water in the pit, it’s time to check the sump pump. If the float switch is triggered and the pump isn’t running, you will need to reset it. Here are some more tips to tell if your sump pump is working.
Additionally, if the pump is running continuously, this is also an indication that it needs to be reset. This could be caused by a clog in the discharge pipe, or a problem with the float switch.
Sump pumps should only run for a short period of time, so if it is running continuously, there is definitely an issue. The sump pump is used for removing the excess water in your house and you need it running properly.
How to Reset a Sump Pump
If you need to reset your sump pump, follow these steps:
Locate the reset button on the motor
The first step is to locate the reset button on the motor. This is usually a red or black button, and it may be located under a cover. If you can’t find the reset button, consult your owner’s manual.
Look inside the sump pump
You need to make sure that there is nothing blocking the impeller. The impeller is the part of the pump that moves water through it. If there is something blocking the impeller, such as a rock or piece of debris, remove it and then try to reset the sump pump again. You should also make sure to regularly clean your impeller in order to keep your pump running smoothly and quietly.
Check for power
If your sump pump is plugged into an outlet, make sure that there is power to the outlet. You can do this by plugging in a lamp or other device in the same outlet, and seeing if it turns on.
If there is no power to the outlet, you will need to either reset the circuit breaker or replace the fuse.
Push the reset button
Once you have checked for power and cleared any debris from the impeller, you should be able to reset the sump pump by pushing the reset button.
Test the sump pump
After you have reset the sump pump, it’s a good idea to test it to make sure it is working properly. To do this, simply add some water to the pit and wait for the pump to turn on.
Once the pump kicks on, it should start removing the water from the sump pit. If it doesn’t, you will need to repeat the steps above. Sump pump problems can usually be fixed with a simple reset, but if the problem persists, you may need to call a professional.
Types of Resetting Buttons for Sump Pumps
There are two types of resetting buttons for sump pumps: automatic and manual.
1. Automatic resetting buttons
These buttons will automatically reset the sump pump when the power comes back on. This is the most convenient type of button, as you don’t have to do anything to reset the pump.
2. Manual resetting buttons
These types of buttons require you to press them in order to reset the sump pump. After you have pressed the button, the pump should start working again.
Frequently Asked Questions
What is the most common reason for sump pump failure?
The most common reason for sump pump failure is a power outage. If the power goes out, the pump will not be able to operate, which can then lead to flooding.
How do drain lines become clogged?
Drain lines can become clogged with debris, such as leaves or twigs. Additionally, if the drain line is not installed properly, it can sag and trap debris.
How deep should a sump basin be?
A sump basin should be at least 18 inches deep in order to accommodate a standard sump pump. This will ensure that the pump has enough room to operate properly.
Should I turn off the electrical system before working on the sump pump?
Yes, it is always a good idea to turn off the electrical system before working on any type of electrical devices, such as a sump pump.